Products from BAR-TEK® Motorsport

BAR-TEK® Motorsport
Close filters
 
from to
1 From 62
NEW
5.2L FSI Audi R8 Gen.2 & Lamborghini Huracan V10 VF800 Kompressor Kit
5.2L FSI Audi R8 Gen.2 & Lamborghini Huracan...
Komplettes Kit mit Kompressor und Einbaumeterial Zur Leistungssteigerung auf bis zu 800 PS und ca. 600 Nm VF Kompressorkits made-in-USA bieten das Rundum-sorglos-Paket. Die Kits sind ausgeklügelt bis ins kleinste Details und...
34,990.95€ *
NEW
UNIVERSAL
Titanium distillate 150ml BAR-TEK®
Titanium distillate 150ml BAR-TEK®
The BAR-TEK® Titanium Distillate is our latest development in the field of corrosion protection, rust solution and preservation. The distillate is applied to the material to be protected and creates a protective film, which immediately...
79.95€ *
NEW
UNIVERSAL
VATTIS SEUCHE - special cylinder cleaning additive BAR-TEK®
VATTIS SEUCHE - special cylinder cleaning...
Vattis-Seuche is our latest development in the field of cleaning in engine construction. Vattis-Seuche is THE additive in engine construction when it comes to cleaning cylinders after honing . The additive is applied to the cylinder bore...
Noch 8 Stück im Lager.
14.95€ * 19.95€ *
NEW
UNIVERSAL
DSG DQ250 upgrade Clutch reinforced up to 700 Nm BAR-TEK®
DSG DQ250 upgrade Clutch reinforced up to 700...
Upgrade-DSG clutch kit for all DSG DQ250 6-speed transmissions. In many engines with DSG transmission, the clutch often starts to slip from 500 - 550Nm torque. Therefore the torque must be limited with a performance increase in many...
1,999.95€ *
NEW
1.8T 20V Gleitschienen für Nockenwellenversteller BAR-TEK®
1.8T 20V Gleitschienen für...
2 neue Gleitschienen für alle 1.8T 20V Motoren. Beim 1.8T Motor liegt im Bereich der Nockenwelle bei getunten Motoren ein erhöhter Verschleiß vor. Es ist sinnvoll, die Nockenwellen, aber auch den Bereich um den Nockenwellen herum...
19.95€ *
NEW
UNIVERSAL
Back-up tool for flywheel like VAG VW 3067
Back-up tool for flywheel like VAG VW 3067
With the counter-holder for the flywheel you'll ease the assembly or disassembly enormously. No complicated holding back anymore. Simple and clean. Article also comparable to the original tool number of: VW 3067 The original reference...
29.95€ *
NEW
UNIVERSAL
Catchtank Oil Drain System Dash 6 with Shut-Off Valve BAR-TEK®
Catchtank Oil Drain System Dash 6 with Shut-Off...
Universally applicable system for emptying catchtanks. The aluminium shut-off valve eliminates the need to remove the catchtank. Thanks to the 1 meter long Dash 6 line it can be placed anywhere in the engine compartment and makes...
69.95€ *
NEW
UNIVERSAL
Shut-off valve Dash/AN BAR-TEK®
Shut-off valve Dash/AN BAR-TEK®
Aluminium shut-off valve, universal for use e.g. with our high performance line for building Catchtank system, fuel lines and more. available in Dash 4, 6, 8, 10, 12, 16 Aluminium black anodized Our fittings are marked with the size, so...
From 34.95€ *
NEW
2.0L TSI EA888 Gen.3 MQB Oil Cooler Flange V2 Dash 8 BAR-TEK®
2.0L TSI EA888 Gen.3 MQB Oil Cooler Flange V2...
Our latest oil cooler flange developed by BAR-TEK®. An oil cooler is a must for optimal oil cooling. Especially for vehicles with increased performance. Our flange is now even easier to install. In addition, we have installed a check...
199.95€ *
NEW
1.8L & 2.0L TSI EA888 Gen.3 MQB Oil Cooler Kit V2 BAR-TEK®
1.8L & 2.0L TSI EA888 Gen.3 MQB Oil Cooler Kit...
BAR-TEK® Oil Cooler Kit V2 for 1.8L & 2.0L TSI MQB Gen.3 EA888 engines. Newest oil cooler kit on the market for the 1.8L and 2.0L TSI engine developed by BAR-TEK®. A must for optimal oil cooling. Especially for 3rd generation performance...
399.95€ *
2.0L TSI EA888 Gen.3 MQB Silicone hose from pressure tube
2.0L TSI EA888 Gen.3 MQB Silicone hose from...
Silicone turbo hose with 5 layers for extreme performance increase Our silicone turbo hose has five layers and is therefore particularly suitable for tuning engines, where we drive particularly high boost pressures. This hose easily...
79.95€ *
BMW S55B30 F8X M2/M3/M4 Charge and Boost Pipe Set
BMW S55B30 F8X M2/M3/M4 Charge and Boost Pipe Set
The aluminum charge air pipe replaces the OEM plastic pipes that tend to burst. This defect can lead in the worst case by sucked fragments to an engine damage. The charge pipe made of aluminum has an increased diameter of 76mm compared...
569.95€ *
BMW S55B30 F8X M2/M3/M4 crankshaft safety device
BMW S55B30 F8X M2/M3/M4 crankshaft safety device
With the BMW N55 and S55 engines, the central screw of the crankshaft can loosen over time. This causes the timing to become misaligned, which can result in major engine damage. The center bolt lock, made from T-6061 billet aluminum,...
169.95€ *
2.0L TSI EA888 Gen.3 MQB Seal Kit Race Intake Manifold BAR-TEK®
2.0L TSI EA888 Gen.3 MQB Seal Kit Race Intake...
Complete sealing kit for our MQB Race intake manifold Through the assembly/disassembly of the intake manifold, the seals can be affected or become porous through aging and in the worst case become leaky. To ensure a long-lasting seal, we...
29.95€ *
2.5L TFSI Audi RS3 & TTRS Turbocharger clamp for Downpipe
2.5L TFSI Audi RS3 & TTRS Turbocharger clamp...
2.5L TFSI EA855 Clamp for turbocharger. This clamp is located directly at the outlet of the turbocharger and should always be replaced at Downpipe - or turbocharger change. A leaking exhaust system directly at the turbocharger can lead...
64.95€ *
1.8T & 2.0L TFSI 400 Kpa Ladedrucksensor (Map Sensor) BOSCH
2.0L TSI EA888 Gen.3 MQB 400 Kpa charge...
400 Kpa map sensor for boost pressures above 2 bar for all 2.0L TSI vehicles of the 3rd generation. As the standard sensor cannot process boost pressures above 2 bar, this sensor is absolutely necessary. Attention: The map in the ECU...
79.95€ *
DSG DQ500 Transmission upgrade Oil Cooler Kit BAR-TEK®
DSG DQ500 Transmission upgrade Oil Cooler Kit...
Upgrade Oil cooler kit from BAR-TEK® for all DSG-DQ500 transmissions . Safety through optimum oil cooling for performance-enhanced DSG vehicles. For performance upgrades that go far beyond chip tuning, where high torques are also driven,...
369.95€ *
2.0L TSI EA888 Ölkühler-Kit V2 BAR-TEK®
2.0L TSI EA888 Ölkühler-Kit V2 BAR-TEK®
BAR-TEK® Ölkühler-Kit V2 für 2.0L TSI EA888 Motor der 1. und 2. Generation. Neustes Ölkühler-Kit am Markt für den 2.0L TSI Motor entwickelt by BAR-TEK®. Mit der V2 haben wir uns das Ziel gesetzt, einen Ölkühler zu entwickeln, der sehr...
Im Lager.
349.95€ *
1.8T 20V, 2.0L TFSI & TSI Hardy Washer
1.8T 20V, 2.0L TFSI & TSI Hardy Washer
In addition to angular error correction and a damping function, the Hardy disk has another task: it provides acoustic decoupling of the driveline from the body and thus reduces noise. A defective hard disk generates precisely these...
Nur noch 2 Stück im Lager.
89.95€ *
2.5L TFSI Audi RS3 & TTRS Hardy disc
2.5L TFSI Audi RS3 & TTRS Hardy disc
In addition to angular error correction and a damping function, the Hardy disk has another task: it provides acoustic decoupling of the driveline from the body and thus reduces noise. A defective hard disk generates precisely these...
279.95€ *
2.0L TSI EA888 Gen.3 MQB Hardy Disc
2.0L TSI EA888 Gen.3 MQB Hardy Disc
In addition to angular error correction and a damping function, the Hardy disk has another task: it provides acoustic decoupling of the driveline from the body and thus reduces noise. A defective hard disk generates precisely these...
89.95€ *
1.8T 20V upgrade Cooling Water Flange Kit BAR-TEK®
1.8T 20V upgrade Cooling Water Flange Kit BAR-TEK®
Upgrade Aluminium coolant flange kit for 1.8T 20V engines. The series installed coolant flanges become porous and brittle over time. The 1.8T 20V often struggles with creeping coolant loss, which leads to increased engine temperatures...
Nur noch 2 Stück im Lager.
79.95€ *
UNIVERSAL
O-ring kit for Catchtank BAR-TEK®
O-ring kit for Catchtank BAR-TEK®
Catchtank leaking, or O-ring broken? No problem! If your catchtank is leaking or the o-ring is damaged, this is no reason to throw it away. With our o-ring kit, leaks are now a thing of the past! Included in the kit: 2x O-Ring for...
Im Lager.
19.95€ *
UNIVERSAL
Vacuum valve tester electric BAR-TEK®
Vacuum valve tester electric BAR-TEK®
Tool for testing the tightness of valves. Leakage at the valves leads to rough running of the engine and in the worst case to engine damage. To prevent damage to the engine, we recommend that you regularly check the valve train for...
Nur noch 1 Stück im Lager.
799.95€ *
1 From 62
Viewed
Just pay
Logo Pre-Payment Logo Klarna (Ex SOFORT Logo Paypal Logo Mastercard Logo VISA Logo Maestro Logo VISA electron Logo Postepay Logo Servired Logo Carte Bleue Logo iDEAL
100 % safe shopping
Seal TÜV seal SSL 20 Years BAR-TEK® Motorsport
15 years of motorsport experience
© BAR-TEK® Motorsport GmbH - All Rights Reserved
All prices incl. VAT. and excl. Shipping